. 1 Answer SOURCE: Solution taken from 'Handbook for Huskylock Sewing Machine Models 1001L/1000L/1000' 1. Raise the presser foot by using presser foot lever. When the presser foot is raised, the two thread tension discs in the thread tension control panel are released so that thread passes freely between them.

1. Viking Serger Case

Viking Serger Case

Otherwise thread tension may not be correct. When threading the needle, always be sure to lift the presser foot lever, and also take care to thread in the proper order. Threading order: 1. Upper looper thread (green) 2. Lower looper thread (blue) 3. Double chain stitch looper thread (purple) in case of 5 thread stitch or double chain stitch 4.

Right needle thread (red) 5. Left needle thread or double chain needle thread (yellow) Caution! Because the left thread tension dial (yellow) is used for either the left needle or the double chain stitch needle, these needles will never be used at the same time.

Upper looper (green) sequence: 1. Thread holder (silver triangle openings attached to thread holder stand) 2. Thread guide (flat silver clips just behind thread tension disc) 3. Thread tension disc (circular knobs with numbers for tension setting) 4.

Pull thread around upper looper guide and upper looper 5. Pull thread into hole of upper looper Lower looper (blue) Repeat 1, 2, 3. Pull thread around guide (see color coded chart inside front serger cover). Easy threading mechanism (for lower looper) 1. Pull out the lower looper threading lever 2.

Thread the lower looper and position the thread on hook of the lower looper threading lever. Push the lower looper threading lever back to its basic position while holding the end of the thread. Caution: When returning the lower looper threading lever, always make sure that the two blue triangle marks (directional arrows) meet each other.

Right needle thread (red) Left needle thread (yellow) Important: Thread the needles after threading of lower looper and upper looper. First raise the presser foot lever, and then thread the needle threads in order shown in color coded thread guide. Posted on Oct 20, 2008. 5660 Answers SOURCE: This, is a link to Toshiba Tecra A2 disassembly guide, with photos and instructions. The Satellite A55 uses the same disassembly instructions. At the bottom you will see Page 1: Page 2: Page 3: Page 4: When you go to the link, you will be on Page 1. I don't have any information on a users guide at present, but will post back when I do.

Fe review manual 2014. What is a Powertrain warranty? Bumper-to-bumper warranties typically expire faster than powertrain warranties.

You may also find this useful, Posted on Apr 16, 2009. The foot control is no longer available through Husqvarna Viking. It is available through aftermarket parts distributors and through online sales.Online, it goes for $50-$60. That is a big investment for something that may or may not work.If you go to a local sewing machine dealer, ask them to research and find one for you, they should not be offended at trying it on your machine to make sure that it works properly and suits your needs. I would expect the foot control to cost $65-$75 at a retail store, but you have the piece of mind that it works before you pay for it. Sometimes every book and parts list says 'X' is what you need and you have it in hand before you realize 'Y' is the only one that works for your particular model. You may get free shipping online, but make sure that you will also get no restocking fee if you have to return it.

Nov 15, 2011.